PIR MOTION SENSOR LAMPS SEN006

This module is PIR for Lamps. Its do not need any mircoMCU. You can easy use on your lighting project. There are Light sensitivity adjustment , Lamp Selection Inductive / resistive , Response time adjustment , Overcurrent protection.... 

Further
1.Wide operating voltage: AC110V - 250V 
2.Single-wire system: two lines, with ordinary manual switch connection (no cloth one line, save money trouble).
3.Support ring lamps, T5 lamps, spotlights, transformers, small electrical solenoid valve, mixed load (a variety of different load together) ...
4.The extra-wide delay time adjustment: about 10 seconds - 6 minutes adjustable!
5.Light sensitivity adjustment.
6.Effectively prevent power fluctuations.
7.Mine-protected.

Electrical parameters:

• Power supply:AC100V-250V(50/60Hz)
• Load energy: 5W - 200W
• Power Consunmption: <0.0088W
• Sensing distance : 0 - 7m
• Induction angle :110-140 degrees
• Delay time: 10s - 6 minutes (Default:10s)
• Size:5cm x 4.2cm